Simulation of Biomass Gasification in Downdraft Gasifier Using Aspen Plus

Forfattere

  • Ashok J. Keche Dr. Babasaheb Ambedkar Marathwada University, Aurangabad.
  • G. Amba Prasad Rao
  • Rajendrakumar G. Tated

Nøgleord:

biomass gasification, Efficacy, equilibrium modeling, ASPEN PLUS

Resumé

Generating electrical energy through biomass has advantages besides achieving self-sustainability. Biomass is particularly useful for agriculture dependent economy nations like India. Energy conversion systems based on biomass are particularly interesting because biomass utilization effectively closes the carbon cycle. A comprehensive process model is developed for biomass gasification in an atmospheric fixed bed rector using the ASPEN PLUS simulator. An original equilibrium gasification model using ASPEN PLUS was first built and validate based on experimental data for three different types of feed stocks viz; babul wood, neem wood and mango wood, to arrive at satisfactory performance. Efficacy of a 35kVA rated down draught gasifier was studied in terms gasifier efficiency, tar content and total particulate matter. Electrical output readings were observed to be 23.4 kVA, 22.17 kVA and 20.4 kVA with babul wood, neem wood and mango wood respectively with satisfactory performance. With further increase in fuel input and resistive load, the frequency and voltage were reduced. Significant improvement was achieved with babul wood as fuel. Cooling and filtration systems were adopted to obtain better quality and dirt-free syn gas. It is observed that specific fuel consumption of wood be approximately thrice as high with liquid petroleum fuels for generating same amount of energy. ASPEN PLUS was shown to be well adapted to model the gasification process (equilibrium).The study also revealed that the developed gasifier is a user friendly and a boon to the areas which are not well connected to grid power and decentralized power generation. Keywords: Biomass gasification, Efficacy, equilibrium modeling, ASPEN PLUS

Forfatterbiografi

  • Ashok J. Keche, Dr. Babasaheb Ambedkar Marathwada University, Aurangabad.
    Mechanical Engineering Department

Downloads

Publiceret

2013-08-09

Nummer

Årg. 4 Nr. 2 (2013)

Sektion

Research Articles

Licens

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

_______________

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.