Some Properties of Briquettes Produced from Sawdust and Different Binders using a Fabricated Hydraulic Piston Press

Auteurs-es

  • Ayoade Kuye Department of Chemical Engineering University of Port Harcourt Port Harcourt
  • Daniel Christopher Ini

Résumé

This paper describes a fabricated briquettes hydraulic piston press and some properties of the briquettes produced from sawdust when it was used. The press consists of three basic components: the main frame, the mold and a hydraulic jack fitted with pressure gauge. The parts are readily available in Nigeria and relatively cheap. The piston press was used to produce briquettes at 120 bar compaction pressure using composite sawdust and different cassava based binders. The sawdust particle sizes were also varied. Both, the density and the ash content of the briquettes produced were found be dependent on the sawdust particle size. The flue gas emission from the combustion of sawdust briquettes was found to contain 18.6–56.5 ppm of carbon monoxide (CO), 0.19–0.8 ppm of sulphur dioxide (SO2) and 0.01–0.54 ppm of hydrogen sulphide (H2S). These properties make the briquettes suitable for domestic cooking and possibly for industrial heating.   Keywords: Sawdust, briquettes, hydraulic piston press, biomass waste, air pollutantsCite this Article  Daniel Christopher Ini, Ayoade Kuye. Some Properties of Briquettes Produced from Sawdust and Different Binders using a Fabricated Hydraulic Piston Press. Journal of Alternate Energy Sources and Technologies. 2017; 8(2): 17–23p.

Téléchargements

Publié

2017-07-31

Numéro

Vol. 8 No. 2 (2017)

Rubrique

Research Articles

Licence

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

_______________

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.