Ultimate Moment Capacity of Polypropylene Fibers Reinforced Concrete Beams

著者

  • Prof. S. Arivalagan Proffessor & HOD Dr.M.G.R University Maduravoyal Chennai-95

キーワード:

Polypropylene fibers、 reinforced concrete beams、 plain concrete beams、 flexural strength、 crack

要旨

The flexural behavior of polypropylene fiber reinforced concrete, plain concrete beams with and without reinforcement was investigated. The reinforcement, volume ratio of polypropylene fiber and surface type of polypropylene fiber kept constant for all the beams. All beams had the same dimensions and tested under two point loads. The results showed that polypropylene fibers were effective in reducing the crack width and crack propagation. The results also showed that while polypropylene fibers had only slight effect on the beam stiffness, combining polypropylene fibers, and reinforcement improved the behavior of reinforced concrete beams and changed its failure mode. Also from the results it was observed that introduction of polypropylene fiber significantly improves the cracking behavior. However, only marginal improvement was observed in the case of ultimate load.Keywords: Polypropylene fibers, reinforced concrete beams, plain concrete beams, flexural strength, crack

著者略歴

  • Prof. S. Arivalagan、 Proffessor & HOD Dr.M.G.R University Maduravoyal Chennai-95
    Professor & HOD

ダウンロード

発行日

2012-01-05

巻号

巻 1 号 2 (2011)

セクション

Research Articles

ライセンス

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the manuscript entitled ‘______________’, hereby declare, that the above manuscript which is submitted for publication in the Journal, is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

I/ We have read the final version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship. We also agree to the authorship of the article in the following order:

Author’s name                            Signature (s)

 

 

1. ________________

2. ________________

3. ________________

4. ________________