Stress Analysis of a Mechanical Joint from Recorded Data of a Single Component of Displacement

Autor/innen

  • R Venkatesh Department of Mechanical Engineering, Ernst-Abbe-Hochschule Jena University of Applied Sciences, Germany
  • S Paneerselvam Cummins, Inc., Stoughton, WI, USA
  • RE Rowlands Department of Mechanical Engineering, University of Wisconsin, Madison, WI, USA

Schlagwörter:

Mechanical joints, connections, DIC, stresses

Abstract

The ability to fully stress analyze a pinned/bolted aluminum connector, including the contactstresses at the pin-plate interface, using measured displacement information is demonstrated.This is accomplished by using recorded data from only either one or the other of the two inplanecomponents of displacement. The relatively small pin-hole clearance results in the pincontacting the edge of the hole for an arc distance exceeding 180 degrees. Reliability ofexperimental results is supported by those of force equilibrium and FEM.Cite this ArticleVenkatesh R, Paneerselvam S,Rowlands RE. Stress Analysis of aMechanical Joint from Recorded Data ofa Single Component of Displacement.Journal of Experimental and AppliedMechanics. 2015; 6(3): 23–41p

Autor/innen-Biografie

  • R Venkatesh, Department of Mechanical Engineering, Ernst-Abbe-Hochschule Jena University of Applied Sciences, Germany
    Professor

Downloads

Veröffentlicht

2015-11-16

Ausgabe

Bd. 6 Nr. 3 (2015)

Rubrik

Research Articles

Lizenz

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

_______________

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.