Computational and Experimental Analysis of Nitride Coated Cutting Tools

Авторы

  • Pina Mandar Bhatt Ph.D. Scholar, R K University, Rajkot,Gujarat,India
  • H N Shah Department of Mechanical Engineering, Merchant Institute of Technology, Mehsana, Gujrat, India

Ключевые слова:

Hard coating, nitride coating, physical vapor deposition, cutting tool, force analysis, wear resistance, coefficient of friction

Аннотация

Utilization of harder and tougher cutting tool materials is essential in cutting tool industry.Nitride coated cutting tools are becoming alternative materials for machining various materials due to its high mechanical and tribological properties. Demand for coated cutting tools is increasing because of reduced cutting force, increased hardness and wear resistance.In this research article, the TiAlN and CrN coated cutting tool materials for metal removal are studied and compared with uncoated tool materials for the same application. The inserts were coated using a physical vapor deposition system and machining performances were investigated in a dry turning operation and wear measurement was analyzed. Deformation and stress analysis was done by ANSYS analysis. It was observed that cutting force of TiAlN coated cutting tool was higher as compared to uncoated and CrN coated cutting tool, which reduced the cutting cycle. Tool wear of CrN and TiAlN coated was very less as compared to uncoated cutting tool.Cite this ArticlePina Bhatt, Shah HN. Computational and experimental analysis of nitride coated cutting tools. Journal of Experimental & Applied Mechanics. 2015; 6(3): 65–72p

Биография автора

  • Pina Mandar Bhatt, Ph.D. Scholar, R K University, Rajkot,Gujarat,India
    Mechanical Department, Faculty of Engineering

Загрузки

Опубликован

2015-12-09

Выпуск

Том 6 № 3 (2015)

Раздел

Research Articles

Лицензия

Declaration and Copyright Transfer Form

(to be completed by authors)

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

_______________

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.