Том 6 № 2 (2015)

Research Articles

• Analysis of Hydrodynamic Characteristics of a Squeeze Film in O-Ring Assembly Under the Oscillating Motion

  Muhannad Mustafa, Nusrat Jahan Chhanda

  1-12

  • Требуется подписка PDF (английский) (20 USD)

• Analysis of Injection Moulding Process Parameters on PVC Material via Taguchi-ANOVA

  Amit Kumar, Aseem Dubey, Manoj Kumar Gaur, Vivek Samadhiya

  13-21

  • Требуется подписка PDF (английский) (20 USD)

• Parametric Investigation of Deep Drawing Process for Different Materials: A Review

  Kartik D. Kothari, R. L. Jhala

  22-26

  • Требуется подписка PDF (английский) (20 USD)

• Effect of Polymer Modified Steel Fiber Reinforced Concrete on Bond Strength

  Uttam B. Kalwane, Ajay G. Dahake, Vasudev R. Upadhye

  33-43

  • Требуется подписка PDF (английский) (20 USD)

• Optimization of Process Parameters of Two Way Abrasive Flow Machining by Grey Relational Analysis Coupled with Principle Component Analysis

  Amit Sharma, Vedansh Chaturvedi, M. K. Gaur

  44-56

  • Требуется подписка PDF (английский) (20 USD)

• Hydrodynamic Study of Turbulent Fluid Flow in an Axi- Symmetric Duct with Crescent

  Pritam Das, Snehamoy Majumder, Debajit Saha, Arindam Mandal

  57-69

  • Требуется подписка PDF (английский) (20 USD)

• Multi-response Optimization of Process Parameter of Spark Erosion Electric Discharge Machining Using Principal Component Analysis Coupled with TOPSIS

  RAJKUMAR SHARMA, Vedansh Chaturvedi

  70-80

  • Требуется подписка PDF (английский) (20 USD)