Design and Analysis of Bootstrap Sample and Hold Circuit

Autoři

  • Ankush Chunn DR. B.R. AMBEDKAR NATIONAL INSTITUTE OF TECHNOLOGY, JALANDHAR
  • Harsh Sohal

Abstrakt

This paper describes the design and implementation of open-loop sample and hold-circuit using bootstrap technique, which can be used as front end sampling circuit for high-speed analog-to-digital converters. Different design criteria, viz., speed, power, resolution, linearity, noise and harmonic analysis have been dealt with. Both theoretical analysis and simulation results are carried out. The bootstrap circuit is designed and then compared in a 0.18 and 0.35 μm CMOS process. It is observed that signal-to-noise and distortion ratio (SNDR) and effective number of bits (ENOB) are higher for 0.35 μm technology. But these advantages are at the cost of higher power dissipation. Hence, there exists a trade-off between these performance metrics.Keywords: VLSI, sample and hold, track and hold

Biografie autora

  • Ankush Chunn, DR. B.R. AMBEDKAR NATIONAL INSTITUTE OF TECHNOLOGY, JALANDHAR

Stažení

Publikováno

2014-12-30

Číslo

Vol 5 No 3 (2014)

Sekce

Research Articles

Licence

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.