Weldability of Ferritic Stainless Steel

Autoři

  • Ajai Kumar Pathak Associate Professor Manufacturing Engineering Department NIFFT Hatia Ranchi Ranchi 3 Jharkhand India

Klíčová slova:

Ferritic stainless steel, weldability, microstructure, coarse grain, mechanical properties, corrosion resistance.

Abstrakt

The ferritic stainless steels are generally considered less weldable than austenitic stainless steels. In case of welding of first-generation ferritic stainless steels, rapid grain growth of ferrite takes place in both the fusion zone and heat-affected zone. These coarse grains have very low ductility and toughness. Excessive grain growth can be avoided by using lower welding heat input and or certain types of additives. They are lower in cost and have better resistance to stress corrosion cracking than austenitic stainless steels. They are used in a variety of applications where corrosion resistance, rather than mechanical properties is the primary service requirement. The ferritic stainless steels are generally used in automotive applications such as exhaust system. Recently, global warming and air pollution have become very important factors in selection of any material and process. In case of automotive exhaust system design, the environment can be protected in a better way by increasing the exhaust gas temperature approximately to 900 °C and by reducing the weight of the parts. Excellent heat-resistant properties, especially thermal fatigue resistance, are the required properties of these parts. The conventional manifolds are made of cast iron, which has a poor heat resistance and is relatively heavy in weight. Certain grades of ferritic stainless steel are considered good alternatives of cast iron for this purpose. In the present paper, weldability of ferritic stainless steels was investigated and proper recommendations were made.  Keywords: Ferritic stainless steel, weldability, microstructure, coarse grain, mechanical properties, corrosion resistance.

Biografie autora

  • Ajai Kumar Pathak, Associate Professor Manufacturing Engineering Department NIFFT Hatia Ranchi Ranchi 3 Jharkhand India
    Associate ProfessorNIFFT, Hatia, Ranchi 3

Stažení

Publikováno

2012-11-22

Číslo

Vol 2 No 3 (2012)

Sekce

Case Study

Licence

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.