Improvement of Mild Steel Surface Properties by Fly-ash + Quartz + Illmenite Composite Coating

Autores

  • Ajit Behera National Institute of Technology Rourkela-769008 Odisha, India
  • S. C. Mishra

Palavras-chave:

Composite, fly-ash quartz illmenite, mild steel, plasma spraying, power level

Resumo

Plasma spray of fly-ash composite gives a stable improvement of surface properties for industrially used materials/equipments, which has become a major technological research area encompassing studies in a broad range from medical field, chemical field to ceramic field. In the present investigation, coatings are developed on mild steel substrates using fly-ash + quartz + illmenite composite (in a weight percentage ratio of 60:20:20) at various plasma torch input power levels ranging from 11 to 21 kW DC. Metallographic and chemical characterization of the produced composite coatings was performed with the aid of scanning electron microscopy (SEM) and XRD analysis. The adhesion strength was measured by using coating pull-out method. Maximum adhesion strength 6.56 MPa was found between coating and mild steel substrate. The adhesion strength was found to be higher than that of other fly-ash composite coatings. It was found that the quality and properties of the composite coating are significantly affected by the operating power level of the plasma spray torch.  Keywords: Composite, fly-ash + quartz + illmenite, mild steel, plasma spraying, power level

Biografia do Autor

  • Ajit Behera, National Institute of Technology Rourkela-769008 Odisha, India
    Research ScholarDepartment of metallurgical & materials EngineeringNational Institute of TechnologyRourkela-769008Odisha, India

Downloads

Publicado

2012-11-22

Edição

Vol. 2 N.º 3 (2012)

Secção

Review Articles

Licença

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.