A Novel Technique for Improved Recovery of Mg-Analysis of the Microstructure and Physical Properties

Авторы

  • B. P. Samal Maharaja Institute of Technology, Bhubaneswar, Odisha, India
  • A.K. Misra
  • S.C. Panigrahi
  • S.C. Mishra

Ключевые слова:

alloying, stir casting, hollow shaft, plunger rod, volatile alloy additions

Аннотация

Aluminium-Magnesium alloys are used widely in industrial applications as well as for the preparation of metal matrix composite because of their low density and high specific strength.  Magnesium has a low boiling point and the recovery of magnesium is poor when it is added in pure form particularly as cheaply available turnings to the liquid metal. Magnesium is added to aluminium for increasing its wettability and thus helping in uniformly distributing ceramic particles used as reinforcement. There have been very few attempts to use the magnesium turnings to produce cast Al-Mg alloys in the range of 3-15% magnesium. A modified stir casting technique was developed using a plunger for making alloy addition by the casting route utilising cheap magnesium turnings. The recovery of Mg was close to 90% and even higher, when added in the form of turnings. In this paper, the density of Al-Mg alloy is predicted with a quadratic model. Also, the percentage of decrease in density for the magnesium alloys increased with increase in magnesium addition and the relation can be represented by a quadratic equation. This technique will be effective on improving the recovery of alloy additions with low density high volatility.   

Биография автора

  • B. P. Samal, Maharaja Institute of Technology, Bhubaneswar, Odisha, India
    Professor, Dept. of Mech. Engineering

Загрузки

Опубликован

2013-04-10

Выпуск

Том 3 № 1 (2013)

Раздел

Research Articles

Лицензия

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.