Drilling of Composite Materials: A Review

Авторы

  • T. Vijay Krishna Kanth Department of Industrial Engineering, GITAM University, Visakhapatnam, India
  • V. Sai Srikanth Department of Industrial Engineering, GITAM University, Visakhapatnam, India

Ключевые слова:

Composite laminates, Drilling, Delamination, Machining parameters, Optimization.

Аннотация

In today’s world composites are replacing metals due to their superior properties such as light weight; low wear rate etc. Composites are widely used in automobile, aerospace and aircraft structural components. While drilling composite laminates, because of high hardness, they are difficult to machine, which results in low drilling efficiency and undesirable drilling induced delamination. The present paper is intended to focus on review of various works reported on drilling of composites, which includes surface finish, hole geometry, cutting forces, modeling and optimization, such that it will be helpful to the new researchers to identify the unexplored areas and carry out their research.  Keywords: Composite laminates, drilling, delamination, machining parameters, optimization Cite this Article Vijay Krishna Kanth T, Sai Srikanth V. Drilling of Composite Materials: A Review. Journal of Materials & Metallurgical Engineering. 2015; 5(2): 1–10p.

Биографии авторов

  • T. Vijay Krishna Kanth, Department of Industrial Engineering, GITAM University, Visakhapatnam, India
    MECHANICAL ENGINEERING
  • V. Sai Srikanth, Department of Industrial Engineering, GITAM University, Visakhapatnam, India
    Associate ProfessorDept., of Mechanical EngineeringGITAM UniversityVisakhapatnam-530045, INDIA

Загрузки

Опубликован

2015-05-27

Выпуск

Том 5 № 2 (2015)

Раздел

Review Articles

Лицензия

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.