Optimization of Process Parameters by Using CNC Milling Machining on EN-5 Steel

Авторы

  • Raman Brar
  • Manjeet Bohat Mechanical Engineering Department, UIET/ Kurukshetra University, India
  • V P S Kalsi Fabrication Metrology and Calibration Division/CSIR-CSIO, Chandigarh, India
  • Sunil Dhingra Mechanical Engineering Department, UIET/ Kurukshetra University, India

Ключевые слова:

Surface roughness, material removal rate, parameters optimization, EN, taguchi

Аннотация

This paper is to optimize process parameters to minimize the surface roughness and maximize the material removal rate by using CNC milling machine. In this research work due to wide applications and economy of EN-5 mild steel, it is used as a work piece material for machining and the process parameters studied were spindle speed, feed rate and depth of cut. Taguchi L 9 orthogonal had been used with three level of process parameters further analysis is done with ANOVA. Results shows that spindle speed followed by depth of cut have most significant effect on surface roughness and for MRR feed rate followed by depth of cut had most significant effect.  Keywords: Surface roughness, material removal rate, parameters optimization, EN, taguchi Raman Brar, Manjeet Bohat, V P S Kalsi, et al. Optimization of Process Parameters by Using CNC Milling Machining on EN-5 Steel. Journal of Materials & Metallurgical Engineering (JoMME). 2015; 5(3): 1–6p.

Загрузки

Опубликован

2015-09-20

Выпуск

Том 5 № 3 (2015)

Раздел

Research Articles

Лицензия

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.