Low-velocity Impact Studies on Glass Reinforced Composites Using Rubber Microparticles and Silica Nanoparticles Modified Epoxy Resin

Forfattere

  • Jitendra S Tate Associate Professor Ingram School of Engineering Texas State University-San Marcos 601 University Drive, San Marcos, TX 78666 USA
  • Esmer Trevino
  • Swapnil Gaikwad
  • Stephen Sprenger
  • Isidro Rosas
  • Matt Andrews

Nøgleord:

Low-velocity impact, impact energy, post-impact compressive strength, rubber micro-particles and silica nanoparticles modified epoxy resin, glass fiber reinforced polymer composite

Resumé

Low velocity impact studies are conducted on +/−45º stitched bonded E-glass epoxy composites manufactured using vacuum assisted resin transfer molding (VARTM). Two sets of composites panels are produced – One using unmodified epoxy resin (control composites) and the other modified epoxy resin containing both rubber microparticles and silica nanoparticles (modified epoxy composites). Modified epoxy resin blend contained 6.5 wt% rubber microparticles and 8.1 wt% of silica nanoparticles. Studies include evaluation of impact strength (ASTM D7136) and post-impact compressive strength (ASTM D7137); measurement of impact damage area, and TEM analysis to evaluate whether microparticles and nanoparticles filter out when resin flows through the glass fabric had occurred. Three specimens tested at each distinct impact energy level. The modified epoxy composites specimens appeared to have superior impact energy dissipation to surrounding area when compared to their control composites counterparts.

Forfatterbiografi

  • Jitendra S Tate, Associate Professor Ingram School of Engineering Texas State University-San Marcos 601 University Drive, San Marcos, TX 78666 USA
    Associate Professor of Manufacturing EngineeringIngram School of EngineeringTexas State University-San Marcos

Downloads

Publiceret

2013-04-13

Nummer

Årg. 3 Nr. 1 (2013)

Sektion

Review Articles

Licens

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.