Design of a Closed Loop Boost Converter with Parametric Variation Analysis of PI Controller for Constant Output Voltage Applications

Autoři

  • Shetu Roy Department of Electrical and Electronics Engineering, American International University, Bangladesh
  • Mohammad Abdul Mannan Department of Electrical and Electronics Engineering, American International University, Bangladesh

Klíčová slova:

Boost Converter, Duty Cycle, PI Controller, PWM Generator (DC-DC), Trial & Error Method

Abstrakt

The DC-DC converters have an unregulated input dc voltage and a constant or regulated output dc voltage. Switching DC-DC voltage converters have two elements: A controller and a power stage. The power stage regulates the switching elements and converts input voltage to output voltage. The controller controls the switching operation to regulate the output voltage. The two systems are linked by a feedback loop that compares the actual output voltage with the desired output to derive the error voltage. This paper will focus on modeling, analysis, design and simulation of DC-DC boost converter architecture and will present an optimized controller for constant voltage applications. The constant output applications have been established by using pulse width modulation (PWM) with a proportional-integral (PI) controller. PI Controller is the most widely used controller in various industrial & technological applications. Here, trial and error method is used to set the controller parameters & to get constant outputs. The calculations of the boost converter have been examined through simulation results using MATLAB Simulink.   Keywords: Boost converter, duty cycle, PI controller, PWM Generator (DC-DC), trial & error methodCite this Article Shetu Roy, Mohammad Abdul Mannan. Design of a Closed Loop Boost Converter with Parametric Variation Analysis of PI Controller for Constant Output Voltage Applications. Journal of Power Electronics and Power Systems. 2016; 6(3): 1–13p.

Stažení

Publikováno

2016-12-03

Číslo

Vol 6 No 3 (2016)

Sekce

Research Articles

Licence

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.