Effects of Fracture Properties on Oil Recovery in Tight Reservoirs

Authors

  • Fuseinatu Latif
  • Victus Kordorwu
  • Kwabena Okyere Nyako
  • Joel Teye Tetteh
  • Quaye Carl Anthony

Keywords:

Hydraulic fracturing, Fracture geometry, recovery factor, oil recovery

Abstract

Unconventional reservoirs, characterized by low permeability are gradually becoming a force to reckon with in today’s world owing to the rapid depletion of conventional resources. However, low oil production from tight reservoirs can be mitigated by implementing hydraulic fracturing. In this study, Schlumberger’s eclipse-100 simulator was used to simulate various scenarios in order to determine the best fracture geometry and the effects of fracture properties on oil recovery. The properties considered were fracture half-length, width and number. Oil recovery from the tight reservoir was found to be 0.47% OIP and the application of hydraulic fracturing increased the recovery to 4.78%. OIP sensitivity analysis was carried out by varying well trajectory, porosity, permeability and wettability. It was found out that, fracture geometry of 300 ft half-length, 1 inch width and a fracture number of 15 is ideal for this reservoir, both technically and economically. An increase in the fracture number affected the spacing greatly. As the number increased, initial production from the reservoir increased. However, cumulative production declined with continued increase in fracture number as spacing decreased. The fracture half-length had a more significant impact on the early time behavior as a result of the fractures reaching further into the reservoir. Increase in fracture width impacted on the late time production behavior of the well by maintaining production for a longer duration. Variations in the reservoir properties after obtaining the optimum case show that hydraulic fracturing is applicable to tight reservoirs.  Keywords: Hydraulic fracturing, fracture geometry, recovery factor, oil recovery Cite this Article Fuseinatu Latif, Victus Kordorwu, Kwabena  Okyere-Nyako  et al. Effects of Fracture Properties on Oil Recovery in Tight Reservoirs. Journal of Petroleum Engineering and Technology. 2016; 6(3): 12–31p.

Author Biographies

  • Fuseinatu Latif
    Department of Petroleum Engineering, Kwame Nkrumah University of Science and Technology, Kumasi-Ghana: BSc Petroleum Engineering
  • Victus Kordorwu
    Department of Petroleum Engineering, Kwame Nkrumah University of Science and Technology, Kumasi-Ghana: BSc Petroleum Engineering
  • Kwabena Okyere Nyako
    Department of Petroleum Engineering, University of Louisiana at Lafayette-USA: MS Petroleum Engineering
  • Joel Teye Tetteh
    Department of Chemical Engineering, University of Utah, Salt Lake City-USA: MS Petroleum Engineering 

Downloads

Published

2016-11-07

Issue

Vol. 6 No. 3 (2016)

Section

Research Articles

License

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.