An FPGA-based Controller Design for Servo Actuator Using Xilinx System Generator and HDL Cosimulator

Autoři

  • thangavel ananthan National Institute of Technology-Calicut Kerala India
  • M. V. Vaidyan National Institute of Technology-calicut,kerala
  • M. V. Varghese Trainee, Kerala state electricity board calicut-kerala

Klíčová slova:

FPGA design, PID controller, servo actuator, HDL cosimulation

Abstrakt

This paper aims at designing a Field programmable gate array (FPGA)-based proportional, integral derivative (PID) controller in a servo-actuated control system. In the conventional method of implementing control systems in FPGA, there is no interaction between the controller and the system except for the final stage of implementing control system in the hardware. The proposed methods provide approaches for analyzing the performance of the controller and system in MATLAB simulink environment prior to the implementation in FPGA. This results in a faster and efficient hardware implementation of digital control system. Two methods developed and used in designing the controller and corresponding simulation results are presented. In addition, a comparative evaluation of the two methods is also discussed. 

Biografie autora

  • thangavel ananthan, National Institute of Technology-Calicut Kerala India
    Research scholarDept of Electrical and Electronics
  • M. V. Vaidyan, National Institute of Technology-calicut,kerala
    Electrical and Electronics, Professor
  • M. V. Varghese, Trainee, Kerala state electricity board calicut-kerala
    Kerala electricity board, trainee

Stažení

Publikováno

2012-05-11

Číslo

Vol 2 No 1 (2012)

Sekce

Research Articles

Licence

Declaration and Copyright Transfer Form

(to be completed by authors)

 

I/ We, the undersigned author(s) of the submitted manuscript, hereby declare, that the above manuscript which is submitted for publication in the STM Journals(s), is not published already in part or whole (except in the form of abstract) in any journal or magazine for private or public circulation, and, is not under consideration of publication elsewhere.

·         I/We will not withdraw the manuscript after 1 week of submission as I have read the Author Guidelines and will adhere to the guidelines.

·         I/We Author(s ) have niether given nor will give this manuscript elsewhere for publishing after submitting in STM Journal(s).

·         I/ We have read the original version of the manuscript and am/ are responsible for the thought contents embodied in it. The work dealt in the manuscript is my/ our own, and my/ our individual contribution to this work is significant enough to qualify for authorship.

·          I/We also agree to the authorship of the article in the following order:

Author’s name                                    

 

1. ________________

2. ________________

3. ________________

4. _______________

 

We  Author(s) tick this box and would request you to consider it as our signature as we agree to the terms of this Copyright Notice, which will apply to this submission if and when it is published by this journal.